GTHound's latest activity
-
GTHound replied to the thread 2L Opel GT e-boost build.So, here is the rough shaped shaft (steps 1 and 2) from above. I ended up buying a set of gage pins (another $135 into project) and... -
-
GTHound replied to the thread 2016 Silverado 1500 5.3L.My 2 cents is that low boost is relatively low risk. However, the work, component cost, engineering, fabrication, motor, power system...
-
GTHound replied to the thread 2L Opel GT e-boost build.Good news and bad news… Bad news: My last motor extension shaft assembly still had too much runout (~0.014") once I figured out a way...
-
GTHound replied to the thread 2L Opel GT e-boost build.That is a brilliant and simple solution. I wish that I had thought of that myself. But, I appreciate you sharing the idea and will...
-
GTHound replied to the thread 2L Opel GT e-boost build.
-
For mesuring your inside hole, you can make go/no-go pin! If you want your hole between *for example* 8 and 8.05mm you can make a go pin...
-
GTHound replied to the thread 2L Opel GT e-boost build.I think that I may have a viable extension shaft! I am basically using a modification of Matnrachs design with extension shaft...
-
-
GTHound replied to the thread 2L Opel GT e-boost build.In hopeful (naive? misplaced?) expectations of a making a viable extension shaft, I have decided that I will plan to balance the whole...
-
