AlexLTDLX's latest activity
-
AlexLTDLX replied to the thread Water Meth injection instead of a Intercooler ?.Yes, I did. I ran dyno tests and track tests. Picked up good power: Here's the data deep dive: Here it is at the track: -
AlexLTDLX replied to the thread I Stand With Ukraine.How are the Ukrainians supposed to hold free and fair elections with international observers when 20% of their territory is illegally...
-
-
AlexLTDLX replied to the thread I Stand With Ukraine.You've been told lies, and unfortunately chosen to believe them - tucker carlson isn't a reliable source (as even the courts have...
-
-
So, here is the rough shaped shaft (steps 1 and 2) from above. I ended up buying a set of gage pins (another $135 into project) and...
-
AlexLTDLX replied to the thread 2L Opel GT e-boost build.I really need a set of gauge pins myself. A one piece shaft is probably the best idea - looking forward to seeing how your turns out.
-
Good news and bad news… Bad news: My last motor extension shaft assembly still had too much runout (~0.014") once I figured out a way...
-
AlexLTDLX replied to the thread Duryea 12v Electric Supercharger.That looks to be a small roots unit like the AMR500. It's highly inefficient and very limited in terms of hp output - just over 100hp...
-
AlexLTDLX replied to the thread 2016 Silverado 1500 5.3L.What GTHound said. Though 2 psi isn't much, 4 psi starts to become very noticeable - it's about the same as 5-6 psi of conventional...
-
My 2 cents is that low boost is relatively low risk. However, the work, component cost, engineering, fabrication, motor, power system...
-
AlexLTDLX replied to the thread Full Time Electric Supercharger - Is it Possible?.Boost at very low rpm is a bad idea. It creates a tremendous amount of cylinder pressure and can cause severe engine damage - it makes...
-
AlexLTDLX commented on tim_reardon@yah's profile post.Not too much activity, but it's building. I'm in the process of moving halfway across the country, so I'm a but inundated with both...
